Thread chaser for O2 sensor bungs
#1
Thread chaser for O2 sensor bungs
If you were like me and had a difficult time getting out your O2 sensors try this.
I used a 18x1.5 spark plug thread chaser to clean the threads on the bungs and it worked.
They are sold as a single unit or as a combination 14x1.5/ 18x1.5
http://cgi.ebay.com/ebaymotors/LISLE...QQcmdZViewItem
I used a 18x1.5 spark plug thread chaser to clean the threads on the bungs and it worked.
They are sold as a single unit or as a combination 14x1.5/ 18x1.5
http://cgi.ebay.com/ebaymotors/LISLE...QQcmdZViewItem
#2
RE: Thread chaser for O2 sensor bungs
good information , I haven't taken mine out yet, but I have been wondering what size threads those were. I have my new pipes and there is a spot of weld spatter on the threads that will have to be cleaned out before I screw anything in there. Thanks for the post......
#5
RE: Thread chaser for O2 sensor bungs
Problem is the factory does not put any antiseize on the threads when installed. Two different metals under extreme heat tend to "fuse". Highly recoomend when you change out exhaust that the sensors get antiseize at install, suprised how many shops are not doing that!
Your local Auto Zone will have thread chasers if you don't want to wait for shipping!
Your local Auto Zone will have thread chasers if you don't want to wait for shipping!
#6
Thread
Thread Starter
Forum
Replies
Last Post