Cross-Reference Table for O-Rings
#1
06-19-2006, 10:42 AM
Cross-Reference Table for O-Rings
I took my selection of transmission, primary, and crankcase o-rings to my local Home-Depot and tried to find matching o-ring sizes there. No great matches, close, but not quite. So does anyone have or know of a cross-reference table for the common o-ring numbers (#6, #10, etc.) to the H-D o-rings? I'd prefer to buy the o-rings in larger quantities and cheaper too rather than at H-D prices. Small cost, just annoying to me.
#3
06-20-2006, 03:04 PM
#4
06-20-2006, 03:57 PM
Cruiser
Join Date: May 2006
Location: So Cal....Sierra Madre
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
#5
07-16-2006, 02:10 AM
RE: Cross-Reference Table for O-Rings
ORIGINAL: OneBlackFly
I took my selection of transmission, primary, and crankcase o-rings to my local Home-Depot and tried to find matching o-ring sizes there. No great matches, close, but not quite. So does anyone have or know of a cross-reference table for the common o-ring numbers (#6, #10, etc.) to the H-D o-rings? I'd prefer to buy the o-rings in larger quantities and cheaper too rather than at H-D prices. Small cost, just annoying to me.
I took my selection of transmission, primary, and crankcase o-rings to my local Home-Depot and tried to find matching o-ring sizes there. No great matches, close, but not quite. So does anyone have or know of a cross-reference table for the common o-ring numbers (#6, #10, etc.) to the H-D o-rings? I'd prefer to buy the o-rings in larger quantities and cheaper too rather than at H-D prices. Small cost, just annoying to me.
Here is a site for o-ring size.
http://www.marcorubber.com/sizingchart.htm
#6
07-16-2006, 08:19 AM
Thread
Thread Starter
Forum
Replies
Last Post
HDF Tech
Primary/Transmission/Driveline/Clutch
1
02-26-2013 11:14 AM
