I am trying to program my bike with a sert and i get an unable to install bootloader what is going on? help thanks

 

Do it again. I found that this happens sometimes. I usually GET ECM info first and then try to program. I think it is a problem with the USB to Serial connector. It will eventually work.

 

same thing over and over again

 

NW,
Did you try changing the setting of the com port on your laptop? You also might need a device driver for the usb to serial cable.

Bart

 

I think this happens around 6% right? What happens when you "Get ECM Info"?

 

it happens at 25%, I can read the ecm info from the bike, I can use the data mode with no problem and the com port is set I am thinking I might need a better quality usb converter. I am going to move the computer from the house out to the shop and try it.

 

nwlang:

Couple of good reads:

https://www.hdforums.com/m_1501034/m...tm.htm#1501034

https://www.hdforums.com/m_1649335/m...tm.htm#1649335

Good Luck!

[sm=icon_cheers.gif]

 

One other thing to try is to open the file and save it again under a different name. Perhaps something is messed up with your file.

 

everything was installed and setup corectly ended up using a computer with a real serial port and had no problems

thanks all!!

 

Same here !!!!
Tks 4 all !
Problem solved

I tryed with other computer with a real serial portand work out !