drive belt broke
#11
Well I had to remove the right rear exhaust to remove the rear axle bolt then loosen up the rear exhaust at the jug and loosen holding clamps to remove bolts on swing arm end plates right side. next is removing swing arm bolt to drop swing arm to install new belt
#14
ok well an update to this I have since removed exhaust on the right side in order to get the swing arm cover off then had to remove rear tire and loosen bolts on exhaust rear jug to swing exhaust out to get bolts off also had to remove pipe strap by brake pedal I loosened and removed swing arm nuts and spacer and bushing put drive bar on end of axle shaft taped with slug hammer bolt came right out no problem what so ever lucky thing I have heard that these get stuck and seeing I have it on a frame lift I was somewhat concerned about having to drive it out that the bike may slide on the lift no worries anyway now its removing swing arm and putting on new belt then reversing the process and torque every thing to specifications
#15
video of work performed
the video shows the inner primary cover removed also the swing arm bolt removed still need to remove shock bolts at bottom to slide the swing arm out then ready to put on new belt and begin reassembly. the parts on the bench are only shown as a reference to how they are setting while off the bike
Thread
Thread Starter
Forum
Replies
Last Post
hvymetal1234
Touring Models
31
05-23-2018 01:08 PM