Mark this thread as Unsold
Looking for some dyna mag wheels
#11
Definitely keep your eye on the classifieds here. That's how I got mine and paid 400 I believe. I had them powder coated black. I'm thinking about some fat spokes. If that ever happens, mine will be for sale.
#13
I put a set of 08 WideGlide mags on mine. The bearings were 25mm and I have 1" axles. Pulled the bearings and replaced them with 1" bearings, set up the proper spacing to get the front centered, rear fit perfect and off I rolled. I did not have to change the center spacer, as it worked fine with the 1" axle.
Now I have a set of like new laced rims sitting in my garage.
Now I have a set of like new laced rims sitting in my garage.
Last edited by Gommee; 10-11-2012 at 04:50 PM.
#16
It took me a few months to get mine of ebay , but with a little patience I was able to get the front wheel and rear wheel for under $300 for the set. I bought them seperatley then sent them out to the powerder coater. So total cost after powder coating and wheel puchase was $480 not a bad deal. When you search on ebay just do search on HD wheels . Dont specify your bike modle and year. Ive come to find out when doing it this way you get more dyna mags that pop up. Then just contact the seller to see what size bearings those wheels are running to match it to your bike . 06-07 1 inch bearings 08-12 25mm bearings. Hope this helps a bit and good luck on the search.
#17
I have a set of mags off my 02 Dyna. They have 3/4" bearings and the center hole on the wheel will need to be bored so that the crush tube will fit in but I can make you a decent deal. I also have another set off a sporty that I believe have 1" bearings. $350 per set. I'll get some pics Monday when I get in to work. Give me a call at the shop and I can get you the specs. The mags off the sportster I believe they have 1" in one wheel (will not need to be bored out) and 3/4" in the other (will need to be bored. We can bore them out for you too.
Last edited by Hogpro; 12-16-2012 at 07:58 AM.
Thread
Thread Starter
Forum
Replies
Last Post