Lifter travel limiters
#11
Just so you all know, I measured a set of lifter travel limiters and the measured .115" not the assumed .100"
And yes you can a adjust them till totally collapsed and leave them right there. The growth of the motor will decrease preload as it warms up..
I thought that 1 full turn from collapsed was necessary but found out from @wfolarry that snug is just fine as long as you can spin the pushrod.
And yes you can a adjust them till totally collapsed and leave them right there. The growth of the motor will decrease preload as it warms up..
I thought that 1 full turn from collapsed was necessary but found out from @wfolarry that snug is just fine as long as you can spin the pushrod.
Thread
Thread Starter
Forum
Replies
Last Post
Crewdog151
Oil Archive (no new posts)
4
03-14-2009 12:38 PM