Fuel Moto Pushrods issue
#12
Here is what the adjuster looks like
Here is a helpful video on installing and adjusting the pushrods
Here is a helpful video on installing and adjusting the pushrods
__________________
Jamie Long / Fuel Moto USA
The USA's Leader V-Twin EFI & Performance www.fuelmotousa.com
Contact 920-423-3309
Email jamie@fuelmotousa.com
Jamie Long / Fuel Moto USA
The USA's Leader V-Twin EFI & Performance www.fuelmotousa.com
Contact 920-423-3309
Email jamie@fuelmotousa.com
The following users liked this post:
Rollbar (03-13-2023)
#14
Here is what the adjuster looks like
Here is a helpful video on installing and adjusting the pushrods
https://www.youtube.com/watch?v=y-VV0mK1-5I
Here is a helpful video on installing and adjusting the pushrods
https://www.youtube.com/watch?v=y-VV0mK1-5I
BTW: My bike runs great with tune Lucas sent (on a Sunday evening) and the guy that I talked to on the phone was very helpful. Thank you all for being awesome.
#15
#16
#17
Using the stock tubes is such a PIA even with the pushrod holder tool, I got tired of that and bought the Colony quick install pushrod tubes.
And if you think that using the stock tubes are a PIA, use Loctite like the instructions says an find out why not, I never did on any brand pushrods, let the jamb nut do it's job.
And if you think that using the stock tubes are a PIA, use Loctite like the instructions says an find out why not, I never did on any brand pushrods, let the jamb nut do it's job.
The following users liked this post:
98hotrodfatboy (03-24-2023)
#18
Using the stock tubes is such a PIA even with the pushrod holder tool, I got tired of that and bought the Colony quick install pushrod tubes.
And if you think that using the stock tubes are a PIA, use Loctite like the instructions says an find out why not, I never did on any brand pushrods, let the jamb nut do it's job.
And if you think that using the stock tubes are a PIA, use Loctite like the instructions says an find out why not, I never did on any brand pushrods, let the jamb nut do it's job.
I agree on the no loctite for pushrods. Just not necessary
The following users liked this post:
Schex (03-20-2023)
Thread
Thread Starter
Forum
Replies
Last Post