Please describe.

 

Just keeps ya from slipping the clutch so much. Before it always seemed like it was pulling so hard. It will help when I'm pulling my trailer.

 

If you don't mind splicing something into the trikes wiring harness you could use this http://www.dakotadigital.com/index.c...rod&prd238.htm

 

Thanks for the info. Have you ever done one? Would the splicing be done under the seat or in the fairing? I can do that kinda thing, but I'm not to thrilled about it.

 

There will be basically 4 wires to deal with on an 07 and up.

Hot
Ground
Sensor in
Sensor out

Best to do this under the side cover where the ECM plug is. You will need to find the correct wire numbers via your bike's wiring diagram.

Hint, leave enough of wire so you can adjust the up and down buttons while riding. It's pretty tough to ride and bend over to see the SIM1.

On my 07 EG the ECM plug wire numbers are...

33 (white and green wire) for the sensor in and out.
13 (Black) Hot wire
10 (Black and green) for the ground wire.

Yours may be different.



-wiz

 

Thanks for all of the info. Now I have to decide what to do. I may wait and save for the TTS and a cam, or buy this unit. Either way I may wait til after the TT4 rally then decide.
Larry

 

What are you wiring? I can't remember any wires on the pulley.

 

The speedometer correction device from the link above that your son sent

 

I will say this.... I love the TTS. I just scratched the surface with it and I'm impressed.

 

I just hate to spend that much for the TTS now, being I only need it for the speedo change. Eventually I want to put a cam and pipes on it, but for now it seems a bit over kill.