RB Racing LSR 2-1 Black 2008 Street Glide
#1
RB Racing LSR 2-1 Black 2008 Street Glide
SOLD.
RB Racing LSR 2-1 Black Exhaust System that was on a 2008 Street Glide that was installed in 2013.
Condition – the pipes show some wear, but function perfectly. The finish absolutely sucks. The finish from RB Racing was terrible, they currently have a light coat of VHT Flame Proof on them. I recommend getting these done in a good ceramic coat. You can have a nice exhaust for way under retail if you go that route buying these used and getting a nice coat laid on them. The front shield has a small dent from when the floor boards come up in a hard turn. You can see this in the picture. The large shield was chrome and still has chrome plating under the paint that should be removed – the paint on it now will chip since it doesn’t adhere well to chrome. Can be used as is – but most will prefer a better finish.
Website: https://www.rbracing-rsr.com/lsr21/flhtsleds.html. This is a 1 3/4 turn out exhaust. I paid over $1000 for this last year. Call RB Racing to see if it will fit your touring bike. I assume it will not fit 2009 and later.
Performance – I pulled 98TQ on a dyno with a 96 inch engine with this pipe installed.
Included:
Front and rear headers
Exhaust pipe
3 shields
Mounting plate (goes under transmission)
Hardware (except listed below)
Instructions
Not included:
Exhaust Seals
Exhaust Rings / Flanges (use whats on your bike)
Exhaust Nuts (use what is on your bike)
Exhaust Shield Hose Clamps (these keep shield on - get at auto/home depot)
$375
RB Racing LSR 2-1 Black Exhaust System that was on a 2008 Street Glide that was installed in 2013.
Condition – the pipes show some wear, but function perfectly. The finish absolutely sucks. The finish from RB Racing was terrible, they currently have a light coat of VHT Flame Proof on them. I recommend getting these done in a good ceramic coat. You can have a nice exhaust for way under retail if you go that route buying these used and getting a nice coat laid on them. The front shield has a small dent from when the floor boards come up in a hard turn. You can see this in the picture. The large shield was chrome and still has chrome plating under the paint that should be removed – the paint on it now will chip since it doesn’t adhere well to chrome. Can be used as is – but most will prefer a better finish.
Website: https://www.rbracing-rsr.com/lsr21/flhtsleds.html. This is a 1 3/4 turn out exhaust. I paid over $1000 for this last year. Call RB Racing to see if it will fit your touring bike. I assume it will not fit 2009 and later.
Performance – I pulled 98TQ on a dyno with a 96 inch engine with this pipe installed.
Included:
Front and rear headers
Exhaust pipe
3 shields
Mounting plate (goes under transmission)
Hardware (except listed below)
Instructions
Not included:
Exhaust Seals
Exhaust Rings / Flanges (use whats on your bike)
Exhaust Nuts (use what is on your bike)
Exhaust Shield Hose Clamps (these keep shield on - get at auto/home depot)
$375
Last edited by Skul5; 03-30-2015 at 10:34 AM.
Thread
Thread Starter
Forum
Replies
Last Post
1sweetglide08
Touring Parts
3
08-14-2012 11:16 AM