Compression Releases
#1
09-04-2012 | 04:19 PM
Thread Starter
|
Tourer
Joined: Dec 2010
Posts: 460
Likes: 1
From: Frisco TX
Compression Releases
SOLD
I have a pair of Screamin Eagle Manual Compression Releases that have about 750 miles on them from a previous build. They are in perfect condition. Would like to get $30 shipped paid via paypal to the lower 48.
From the Harley Catalog:
P/n 94638-08. Sold in pairs.
I have a pair of Screamin Eagle Manual Compression Releases that have about 750 miles on them from a previous build. They are in perfect condition. Would like to get $30 shipped paid via paypal to the lower 48.
From the Harley Catalog:
Screamin’ Eagle Pro mechanical
comPression release
these compression releases may be used to ease starting
on high-compression engines, especially Stroker flywheelequipped
models. releases are activated by pushing on
the top before starting, which reduces cranking pressure,
and allows the engine to spin over easier. After the engine
starts they automatically close to restore full compression.
Installation of these compression releases may require
machining of the cylinder head. this operation should
only be performed by a competent machinist, or by using
Mechanical Compression release Machining Fixture
comPression release
these compression releases may be used to ease starting
on high-compression engines, especially Stroker flywheelequipped
models. releases are activated by pushing on
the top before starting, which reduces cranking pressure,
and allows the engine to spin over easier. After the engine
starts they automatically close to restore full compression.
Installation of these compression releases may require
machining of the cylinder head. this operation should
only be performed by a competent machinist, or by using
Mechanical Compression release Machining Fixture
P/n 94638-08. Sold in pairs.
for race application only.
32076-04
$84.95
Fits all Screamin’ eagle twin Cam Cylinder Heads (except
heads equipped with Automatic Compression release).
Last edited by Energy-Dude; 09-05-2012 at 09:31 AM.
Thread
Thread Starter
Forum
Replies
Last Post