SOLD I bought these CVO slip on's from a board member and don't like them they are too quiet. They are in very good condition I would like to get $190 shipped because it will cost me $40 to ship them.

 

PM sent

 

If you like the looks but want louder/better performance you could keep them and replace the baffles with the Fullsac CVO Power Cores. They come in 1.75", 2.0", 2.25", and 2.5". The larger the louder but you start loosing low end torque when going over 2". http://fullsac.com/product/2006-2015-cvo-power-core/

 

What Greg said.

Did the exact thing with my CVO pipes. Ground out the welds with a dremmel tool, put a piece of pipe in the head end of the slip on. A couple of good whacks and out came the stock baffles. Must say I was pretty amazed at the amount of restriction the stock baffle had. Replaced them with Fullsac 2.5 baffles. (stripped out all of the fiberglass) Bike sounds great. Barks when needed is humble when needed. I get many compliments from my friends on how it sounds. A lot less expensive than the hunt for a good sounding slip on. My advice would be to give it a try. Will save you some $$$

 

I will trade you a set of 4in jackpots slash up for them,if you want louder.

 

what condition are these in? what would you sell them for if you did?

 

decided to keep them and try the fullsac baffles.

 

smart move.. damn good setup.

 

I just put the 1.75" Power cores with the muffler screens and half the packing that Fullsac recommends in mine today and I don't think they are any louder than stock. But they are a deeper tone. The bike definitely pulls harder especially in the higher gears. If you want louder I recommend you go with the 2" or larger Power cores. On a side note, Fullsac told me the larger the core the louder it will be, but you will loose some low end torque if you go larger than the 2.0".