Woodgrain dash kit??
#12
RE: Woodgrain dash kit??
ORIGINAL: jefkat2
This web site is where you need to go. Had work done for my Jeep by them.
http://www.phoenix-image.com/HydroGraphics.htm
2007 FLHTC
This web site is where you need to go. Had work done for my Jeep by them.
http://www.phoenix-image.com/HydroGraphics.htm
2007 FLHTC
#13
#15
RE: Woodgrain dash kit??
#16
RE: Woodgrain dash kit??
They're not the same fairing. If you don't find one, you might have to make one if you're handy enough. Around here there's a place called Owl Lumber, years ago I had an Alfa that had speaker holes cut into the kickplates on the doors instead of under the dash where they belonged. I bought Mahogany veneer to match the steering wheel and cut to fit. Sanded, sanded, sanded then sprayed with spar varnish (marine). Contact cement after roughing the plastic and clamped at the curves. Never came off. Dash guys who sub at car dealerships use contact cement in addition to the adhesive on the kits, heat guns get real hot, use a blow dryer instead. Veneers are thin enough to cut with a razor knife/exacto blade. I'll be capping a beam at the house with red oak veneer I just bought from them this spring, it's not really that hard.
Thread
Thread Starter
Forum
Replies
Last Post
Terminator69
Touring Models
17
02-02-2010 02:33 PM