I'm in the process of putting a detachable tour pak mount and SG turn signal bar on my EG Classic so I can ride stripped down once in a while. Was going to put plate below bar with a curve mount but with the fender tip light looks like that fills the whole fender in not sure I like that look. I have seen a couple of guys with plates below fender tip hanging down, looking for anyone that did this and what they used.

 

I've been looking for other options to get mine below my tail light too. Subscribed.

 

got this bracket with built in light from custom dynamics. I believe JP sells it also.

 

Miracle where you from see a Mahoning county tag, Im in Liberty

 

here's a 2010 road king signal bar plate mount on an 09 FLHTC:



pretty much plug and play, the plate leds need to be spliced or married into a run light circuit.

it does kinda fill the area, but it works


mike

 

I just hate having no paint showing from rear looks cluttered

 

Check your State motor vehicle laws. Some have have minimum mounting heights.

 

yeah I know, but when I mocked up a plate in other locations it didn't look any better...mudflap position, on the crash bars etc.
the relocate kit with the detach kit looks like a spoiler.

however, you don't see it when running down the road!

and as above, it is DMV ok

mike

 

https://www.hdforums.com/forum/touri...lo-seat-6.html. Page 5,6. Not a SG but a EG.

 

jgr, from a-town