Yes,I posted about it a while ago. It had happend to me again, I went right to the splice my HDealer did and peeled back the sheath and took the tape off the ugly splice they did and found that they had only spliced 3 of the 6 wires running from the grip!!!! So while I was at it I found some better looking nylon sleeve material and pulled all the wiring through it after splicing the last 3 wires they didn't.Now they're all the same length, Only one was broken (you have to feel for it because the wire is broken/shorting inside its' insulation) Anyways it's all good now.



From a similar thread,
https://www.hdforums.com/forum/newre...ply&p=11695890

 

Where about is this on your bike? In between the tgs and the throttle body I take it? Thanks Jason.

 

The Zip-Tie in the photo, Wiring is a bit short and Zip-Tie way too tight, After many right/left turns it breaks down the wires.
I was busy editing/adding stuff to last post.

 

BTW, Here's a photo of my left side harness, It had nearly cut my FM Antenna cable in half and broke a wire in the ABS sensor wire coming up from wheel. Might wanna check the left side as well.

 

I wiggled them wires, I know that isn't a fix, but didn't get the whiskey throttle tonight. Might take it into Harley for them to give it a once over. Thanks for the pics and info!