Automatically going to single cylinder mode
#1
Automatically going to single cylinder mode
Ive noticed my 2013 CVO Ultra goes to single cylinder mode when I idle if the Ive been riding for a while. I do NOT want this to happen. It has to be revved once or it wants to cut out. I thought maybe I had inadvertently rolled the throttle forward, but I took my hand completely off the throttle and it still does it. Any ideas? Thanks in advance
#2
Ive noticed my 2013 CVO Ultra goes to single cylinder mode when I idle if the Ive been riding for a while. I do NOT want this to happen. It has to be revved once or it wants to cut out. I thought maybe I had inadvertently rolled the throttle forward, but I took my hand completely off the throttle and it still does it. Any ideas? Thanks in advance
#3
Ive noticed my 2013 CVO Ultra goes to single cylinder mode when I idle if the Ive been riding for a while. I do NOT want this to happen. It has to be revved once or it wants to cut out. I thought maybe I had inadvertently rolled the throttle forward, but I took my hand completely off the throttle and it still does it. Any ideas? Thanks in advance
Copied here in case you don't have one.
Vehicles are delivered from the factory with EITMS disabled. EITMS can be enabled or disabled by the rider using the following procedure.
Turn the ignition switch to the ON position (do not start the motorcycle).
Push the throttle to roll-off position and hold.
See Indicator Lamps: Touring Models. After approximately 3 seconds, the cruise indicator lamp will either flash green (EITMS enabled) or red (EITMS disabled).
Repeat the procedure as needed to enable or disable EITMS.
#7
Trending Topics
#8
#9
#10