Air Valve Extension
#1
Air Valve Extension
Anyone know if a 90 degree air valve extension will fit on front wheel of 10 Classic?
I need something just for putting air in and checking, then I'd take it off. There isn't enough room for anything else, like extension hoses. I don't like bending valve stem.
This is what I'm looking at. Not sure if there is room to screw it on.
http://automotive-hardware.com/1-pcs...bend-p-25.html
I need something just for putting air in and checking, then I'd take it off. There isn't enough room for anything else, like extension hoses. I don't like bending valve stem.
This is what I'm looking at. Not sure if there is room to screw it on.
http://automotive-hardware.com/1-pcs...bend-p-25.html
Last edited by Chuck1; 06-15-2013 at 10:47 PM.
#3
I have these and am 100% happy with them:
http://www.motorcycleanchor.com/tire_valves/
I have also seen a knock-off at a local Cycle-Gear and are cheaper.. K&L? If I had to buy more I would go with the "anchors" as I haven't had a problem with them since install and I am sure are made with better materials?
http://www.motorcycleanchor.com/tire_valves/
I have also seen a knock-off at a local Cycle-Gear and are cheaper.. K&L? If I had to buy more I would go with the "anchors" as I haven't had a problem with them since install and I am sure are made with better materials?
#4
#6
I have these and am 100% happy with them:
http://www.motorcycleanchor.com/tire_valves/
http://www.motorcycleanchor.com/tire_valves/
Finally got mine installed and it works fine. I also bought one of those flexible extension things with a guage at the end but didn't use it even one time. Forgot I had it.
#7
Thread
Thread Starter
Forum
Replies
Last Post
trooper50
General Harley Davidson Chat
13
04-25-2012 06:11 PM