Hey there,

Ive got a brand new 2013 SG and i just noticed that my rear fender Tip light is not working. I took my bags and side covers off and traced the wires and everything appears to be plugged in correctly. All fuses are working and rear brake and turn signals work fine.

Im out of ideas at the moment.

Anyone else have this problem?

Thanks in advance.

Mike

 

Anyone with a Canadian bike. There is no light installed.

 

Anyone Experience this at all?

 

Shouldn't it still be under warranty? Have the dealer figure it out.

 

I believe that is correct.....For the 1st poster, did the light work when you first picked up your bike??

 

Is there a bulb? If there is, maybe it's burned out.

 

To be honest i cant remember if it did or not. I didn't know there was a light till i saw a vid on you tube. then i went out and looked and sure enough there is one there, but it doesn't seem to work.

 

I don't think bikes shipped to your country have operating tri bar lights. The lights on the USA bikes consists of a circuit board with 3 or 4 LED bulbs attached to it.

 

I looked over the wiring diagrams and the only thing that it shows is that the front fender lamp is for domestic (USA) models from diagram #B-23. On diagram #B-22 it shows that the rear fender lamp is present, however there is a facia/converter module between the rear lamps (tail running, stop/brake, L/R turn signals & fender/license). The running lamps (and here I would assume would include fender/license) go back to the Lights 15A fuse. Unless I am missing something here, the diagram shows only one bulb and it is listed as fender/license. It is avery good possibility the Lonewolf176 is correct, especially since he is from Canada. Just trying to offer a possible solution. Only the Canadian and HDI models use the facia/converter module.