in-lbs torque wrench
#12
I work as an inspector, part of my job is calibration of gauging equipment. I can tell you that the ratchet style t-wrenches that Harbor Freight sells are terrible. Spend the money to get a quality wrench like a Snap-on etc.
Some auto parts stores will lend, or rent a quality wrench if you're only going to use it once.
Some auto parts stores will lend, or rent a quality wrench if you're only going to use it once.
#13
#14
The last time I was at Sears they had several types of inch/pound wrenches. I can’t recall if their inch wrenches went that low. I have an inch wrench and it starts out at 30 and goes up to (I think) 120 inch pounds. Anytime I get something that dictates less than 30 inch pounds I simply “judge” the pressure (basically snug down the screws/bolts to where they just hit and then slightly give them a little more). I think you just need to be smart and not get carried away. I just went through this with the brake master cylinder covers (I believe they were something like 18-20 inch pounds).
#16
#19
Hilarious!!!
There are things that I will buy cheap, but a torque wrench is not one of them. Most tools it either works or it doesn't. If it doesn't you know it. How are you going to verify that a torque wrench is actually torquing right? Yes, you can get them calibrated, but it ain't cheap.
Digital will cost too much for a garage guy and may need calibration too much. Bar type probably keeps it's calibration best. I use a bar type I borrow from my Dad for in. lbs. Have thought about buying my own but not sure what to buy. After checking prices on pros (Snap-On, Matco, Mac) I went to Sears with an idea of what the Sears one should cost. Sears price blew my mind and still using my Dad's. Think I'm going to buy a Snap-On at some point.
There are things that I will buy cheap, but a torque wrench is not one of them. Most tools it either works or it doesn't. If it doesn't you know it. How are you going to verify that a torque wrench is actually torquing right? Yes, you can get them calibrated, but it ain't cheap.
Digital will cost too much for a garage guy and may need calibration too much. Bar type probably keeps it's calibration best. I use a bar type I borrow from my Dad for in. lbs. Have thought about buying my own but not sure what to buy. After checking prices on pros (Snap-On, Matco, Mac) I went to Sears with an idea of what the Sears one should cost. Sears price blew my mind and still using my Dad's. Think I'm going to buy a Snap-On at some point.
#20
I work as an inspector, part of my job is calibration of gauging equipment. I can tell you that the ratchet style t-wrenches that Harbor Freight sells are terrible. Spend the money to get a quality wrench like a Snap-on etc.
Some auto parts stores will lend, or rent a quality wrench if you're only going to use it once.
Some auto parts stores will lend, or rent a quality wrench if you're only going to use it once.