I bought the radio shack siren, found the connector with a black, green/brown and grey wires. I've searched all of the posts on this issue. I CAN'T GET IT TO WORK! I just get small clicks when the lights flash. Am I doing something wrong or what? It's on a 06 streetglide. It seems like it only works on some models, but not this one. W T F ..........!!!!!

 

Get the HD siren, 5 minute install & be done with it!

 

Hey, can't blame a guy for tryin to save a buck! Get what you pay for i guess......

 

https://www.hdforums.com/m_820390/tm.htm

Check out this link I posted it is a step by step install. If you have a problem IM me.

 

Your only going to get the "clicks" or "Chirps" as some people call them, as you activate the alarm. Once it's "armed' you will see the "armed" light on your dash or speedo, depending on the model, blinking. If you want to test to see if it is working just bump up against it or grab the handle bars and try moving the bike. You will get an audible warning before it alarms.

 

i tried again. still just clicks. even when the alarm is tripped, just clicks. rollntiger, sent you a pm.

 

You found the wrong connector....
The one for the alarm circuit is a three wire delphi sytle with a BLACK WIRE, a GREEN WIRE, and a BROWN WIRE. (No grey wire)

It is located on the right side of the bike.Take off cover, remove ECM, remove plastic ECM mount and you will find the plug in a blank that is attached to the ECM mount.

 

Todd the above post is correct. I sent you a PM.

 

[sm=imsorry.gif]i should have listened. i found the right plug and everything works great! anyone know what the plug is that i was messing with the first time? it had a black, green/brown and grey wire??????

 

Another Rebel robbing the Moco of $80.00! Now got set it off in a crowded parking lot full of other bikers!