2012 SG rear smoked lenses
#12
#13
+1 on the Custom Dynamics LED in rear. I also run the smoked lenses. The LED's require you to pull the old bulb assembly and trim the gasket just a tiny bit. Otherwise the lense won't seat properly. Use a razor blade and took about 15 minutes to do both sides.
Anyone running the new LED running light/turn signal in the front?
http://www.customdynamics.com/Images/IMG_4638-1.jpg
Anyone running the new LED running light/turn signal in the front?
http://www.customdynamics.com/Images/IMG_4638-1.jpg
#14
+1 on the Custom Dynamics LED in rear. I also run the smoked lenses. The LED's require you to pull the old bulb assembly and trim the gasket just a tiny bit. Otherwise the lense won't seat properly. Use a razor blade and took about 15 minutes to do both sides.
Anyone running the new LED running light/turn signal in the front?
http://www.customdynamics.com/Images/IMG_4638-1.jpg
Anyone running the new LED running light/turn signal in the front?
http://www.customdynamics.com/Images/IMG_4638-1.jpg
I agree with other posters. I have the custom dynamics setup with LED front/rear and the plasma rods. the plasma rods are the way to go for further visibility. Everyone that's ridden behind me has commented on how visible they are.
'12 SG stock is duel filament front and rear. The front is duel since they work as driving lights stock.
#15
So I picked up some of the red LEDs from AutoZone and intalled them on one side of the rear for a comparison. They will be getting returned later this afternoon. They're not close to as bright as the stock clear light, red lens set up. I really liked the way they looked when the bike is off but after I turned it on, it was a no go...
#16
So I picked up some of the red LEDs from AutoZone and intalled them on one side of the rear for a comparison. They will be getting returned later this afternoon. They're not close to as bright as the stock clear light, red lens set up. I really liked the way they looked when the bike is off but after I turned it on, it was a no go...
#17
great idea, I'll look for the mod
Thread
Thread Starter
Forum
Replies
Last Post
steelerdude1
Touring Models
14
11-29-2015 06:20 PM