12" Torch Industries, they measure true to size

 

When all was said and done I paid around $550.00, Did the install myself.

 

MSgt1371, how is the reach for you? Could you pull the bars back if you wanted to? I'm 5'7" also and feel like I'm leaning forward too much on the stock bars. I'd like some height on the bars but also some pullback. I like to lean back a bit when I ride. Not sure if the apes will allow me to do that. You have a sweet bike. What seat do you have?

dave

 

I have the 13" Cycle Smith Chubby apes and I am only 5'8... They are really comfortable for me, at first I didn't think they would be but turns out I love them!

 

I just saw this, sorry for the late reply. I was having the same issues you were with the leaning forward. These bars allow me to sit straight up. The seat a Danny Gray/Arlen Ness solo. It was on the bike already when I picked it up.

 

I like my 12 inch Yaffe's that I put on.. was a MOTHER.... to wire internally, but well worth it in my opinion.
I am 6ft 4.

 

I put 10" Yaffee's on my '11 Limited. PITA to run the wires but are comfortable.

 

10 inch black wild one chubbies brought me up an inch and back two. I wish I would have gone with the 12.5's but I REALLY wanted to stay behind the fairing because I ride a lot during the winter.

 

Do you have a model #? Were these the wo575 or the wo578?

 

12in Yaffe bars are very popular for the Street Glide. That's what i installed on my 09 SG. The 12 in bars are usually a good fit for anyone of average height. With the cost of the bars, wires, cables, etc., i paid around $550. I did the install myself which is not an easy job. You can figure another $500 [at least] if you have someone else do the install.