Sounds easy enough. What type of fittings for the speakers?

 

The speaker fittings are typically included with your new speakers along with the included speaker wire ... The PBR300X2 is a very easy install. It took me about an hour and 1/2 but most of that time was taking off the gas tank and fairing and reinstalling them....and of course i soldered and heat shrinked every connection .... good luck

 

I don't need no stinking amp.

 

Thank you

 

Just ordered mine yesterday, can't wait to get home and get it installed. I have the Boom Audio fairing speakers and i think they sound pretty decent compared to stock, hopefully this amp really wakes them up. I guess we will find out in a month or so.

 

I have received my 300x2 amp and the RF 6.5 power speakers. After looking at them I noticed that I only have one wire harness that goes in the jack for the output(bare wires on one end and a jack on the other). I also received the rca jacks but understand you get better sound with the high level wire. I do not have a jack that plugs into the input side of the amp. Any thoughts? Guys that have done this install tell me what I need to get

 

read the instructs ,you cut the rca jack for use with speaker level input.

 

LOL who reads those pesky little things

 

I don't think I'm getting the best out of mine. Has anyone used the RCA from an aftermarket radio and then wired the hi level input and was the sound any better????

 

i have the same question.. did u ever find an answer, or try the high level inputs??