Just got back from the Expo. I would have to say a thank you very much from him. I installed a set of TW-555 cams this weekend and had a small issue on the pushrods, talked to him for a few mins. Jamie walked me right through it. And perfect, bike runs very strong with his master tuning abilities. Can't say thank you enough. I highly recommend Fuel Moto and his team!!!!!

 

Did you take your bike to the show or did you install the rods beforehand and then got some advice from Jamie?

 

And what new FM things did you see ?

 

Did they unveil their 2-1 exhaust?

 

I wasn't at the show, but talked to Jamie on the phone a couple weeks ago and he said they were releasing the 2-1 pipe at the expo.

 

He was there with Bob Woods at his setup. Jamie didn't have a booth setup. I didn't take my bike there the install was before and advice afterwards..

 

Yes he had his new 2into1 there. nice looking pipe, polished stainless looked real good. A little bit of carbon fiber on the end cap is a nice change as well.

Jamie, it was nice to finally meet you (even if it was briefly) after talking to you on the phone a few times. It's nice to put a face with the name. It was cool to learn that you used to race against Jess to, i'll have to bring that up when he comes in the shop sometime. Did you ever happen to race against either of his brothers? Will Roeder or George (Geo) Roeder?