PBR 300x2 Amp Install Problem?
#21
Goodboo. Don't think about it too much or you'll scare yourself. Just dig in and do it. My recommendation is;
1. pull the fuel tank off and get it out of the way. it's easy to take off and put back on
2. there is a plastic wire tray under the fuel tank, pop the top off of it and use that tray for your wires. Makes for a very clean install.
3. sitting on the bike, to the left front of the wire tray is a rubber sheathing with wires going through it for the fairing. Take some WD-40, spray inside that sheathing, and your power wires will slip right through them keeping all wiring concealed.
I am VERY **** about wires. I hate to see them, period! I'll spend an extra hour running wires before I allow 1 single wire to show on anything I do. but that's just me.
the rest of it is easy.
1. pull the fuel tank off and get it out of the way. it's easy to take off and put back on
2. there is a plastic wire tray under the fuel tank, pop the top off of it and use that tray for your wires. Makes for a very clean install.
3. sitting on the bike, to the left front of the wire tray is a rubber sheathing with wires going through it for the fairing. Take some WD-40, spray inside that sheathing, and your power wires will slip right through them keeping all wiring concealed.
I am VERY **** about wires. I hate to see them, period! I'll spend an extra hour running wires before I allow 1 single wire to show on anything I do. but that's just me.
the rest of it is easy.
#23
#24
Thread
Thread Starter
Forum
Replies
Last Post