Rokker system ordered!!
#31
#32
#33
#34
well let's see ,,,,,
most of you are in business right ? ,,, and we DO appreciate all of our good customers ,,,,
back to the foam ,,, we have to buy and entire BIG BRICK of that fire-resistant charcoal gray foam each time ,,, I think it is around $2,500 per brick/bun ,,,,
then the guy down the street has to cut it in layers with a special knife, then run it thru the die-cut machine for each piece, then apply the cool pre-gummed foam backing ((or is it the other way around?)) ,,,,,
then take the install instructions we give him, and bag each set up properly and not mix any up ,,,,,
then it is delivered to J&M ,,, I have to pay someone to stock it in our warehouse and then bring it over here to be combined with the speaker kits, or sold separately by itself ,,,,
THEN if I want distributors like Drag Specialties to stock and distribute it, and dealers like your local Harley dealer to buy it and sell it to YOU, I have to give them each their required profit margin ,,,,
and HOPEFULLY J&M can take home 2-6$ profit from each kit when all is said & done, to help pay for the lights, the dirt we sit on, and some advertising occasionally, no less the approximate $1,000.00 per month it costs to be a sponsor on this web forum alone ,,,,
all I can say is that we do the very best that we can ,,,,,
most of you are in business right ? ,,, and we DO appreciate all of our good customers ,,,,
back to the foam ,,, we have to buy and entire BIG BRICK of that fire-resistant charcoal gray foam each time ,,, I think it is around $2,500 per brick/bun ,,,,
then the guy down the street has to cut it in layers with a special knife, then run it thru the die-cut machine for each piece, then apply the cool pre-gummed foam backing ((or is it the other way around?)) ,,,,,
then take the install instructions we give him, and bag each set up properly and not mix any up ,,,,,
then it is delivered to J&M ,,, I have to pay someone to stock it in our warehouse and then bring it over here to be combined with the speaker kits, or sold separately by itself ,,,,
THEN if I want distributors like Drag Specialties to stock and distribute it, and dealers like your local Harley dealer to buy it and sell it to YOU, I have to give them each their required profit margin ,,,,
and HOPEFULLY J&M can take home 2-6$ profit from each kit when all is said & done, to help pay for the lights, the dirt we sit on, and some advertising occasionally, no less the approximate $1,000.00 per month it costs to be a sponsor on this web forum alone ,,,,
all I can say is that we do the very best that we can ,,,,,
#36
#37
yea, that wasnt tough at all...except for the bonehead that had my scoot previously went in and f'd with the internal wiring so i had to make new connectors and what not.... hardest part was the damn harness bolts just cause of the location... J&M sure did make it dummy proof....sh*t it's even MARINE proof. sounds good in the garage at low speeds (like not moving, lol) cant wait to take it out for a ride and check it on the highway. later all
Thread
Thread Starter
Forum
Replies
Last Post
TXcruzin
2014-2023 Touring Models
10
03-25-2015 03:11 PM