Looking for a 1 7/16" torque adaptor for rear wheel nut, is that a crows foot or is it like the engine snap-on torque adaptors that I have? Where did anyone purchase theirs? Thanks.

 

Anyone? Bueller?

 

I made mine. I went to Northern Tools and bought a 1 7/16 wrench for $10.00 and a 1/2 drive X 3/4 socket for $2.00. Cut the wrench to where it would clear the muffler and then cut the socket because all I needed was the part the torque wrench would fit in and then I welded the socket to the cut off wrench. Cheap and it works.

 

Uh, hey there ... First off it is a 36 mm, secondly, you can get a wrench from Pit Posse.... HERE.....

Actually, you will need 2 to do it correctly....

 

36MM=1.417"
1 7/16=1.437"

 

Thanks shovelhead that is what I was looking for. So, I need two of them??

 

I used a socket with a torque wrench, don't forget anti-sieze on the axle!

 

Here ya go!!

http://cgi.ebay.com/ebaymotors/Motor...QQcmdZViewItem

 

I need one of those too , could you just torque the one end with the wrench and hold the other end with a regular wrench ?

 

The harley tool kit that comes with the bike has a 36 mm wrench in it , with a allen hole in one end you can torque the bolt with.