Handlebar install
#1
Handlebar install
Hey all,
I have some WO575 that should be here this afternoon...so I started taking the bike apart. So far so good, I have the old bars off and am waiting for FEDEX. I started to look at the left switch harness to see what will need to be done to put the wires internal when I put everything back together. I saw one set of pictues that showed the plug being disassembled, wires run and then I assume reassembled in place. I can't seem to get the plug apart. Is this the only way to do this or will I need to cut and solder spice the wires? I am feeling a little overwhelmed as this is the farthest I have been into my bike yet. Thanks for any help!
By the way, I am working on a 2010 Limited. Thanks again.
I have some WO575 that should be here this afternoon...so I started taking the bike apart. So far so good, I have the old bars off and am waiting for FEDEX. I started to look at the left switch harness to see what will need to be done to put the wires internal when I put everything back together. I saw one set of pictues that showed the plug being disassembled, wires run and then I assume reassembled in place. I can't seem to get the plug apart. Is this the only way to do this or will I need to cut and solder spice the wires? I am feeling a little overwhelmed as this is the farthest I have been into my bike yet. Thanks for any help!
By the way, I am working on a 2010 Limited. Thanks again.
#4
I have the HD pullback bars. I installed and internally wired them myself. It was a pain but not too bad. Make sure you draw a picture of what color wires came out of what hole so you can get them in the right place when you put them back together. It'll sure look a lot better than that wiring harness cable wrapped to the handlebar.
#5
Good luck...
#7
Trending Topics
#8
#9
#10
Thanks for your help and I didn't intend to hijack the thread.
Ride safe!
Last edited by dhincc; 06-15-2011 at 03:09 PM.