Only one speaker works after CB disconnect?
#1
06-06-2011 | 08:40 PM
Thread Starter
|
Cruiser
Joined: May 2010
Posts: 125
Likes: 0
From: MA
Only one speaker works after CB disconnect?
I just picked up a 97 EG Ultra Classic and I couldn’t stand the CB on the console. I went down to the dealer and picked up a new replacement cover. Everything was hard wired to the board of the CB so there was no bypass plug available from the dealer. I simply disconnected the wired blocks ( kept all intact incase I wanted to put the original CB back on. Wrapped em up and under the seat they went.
After doing this I lost the front right speaker and the rear passenger speakers. Only thing I can think of is there is now an open circuit that must have looped through the cb board in order to close it? Any thoughts? Need to find a wiring diagram to see what wires need to be tied together to close the circuit again? Any help would be great!
After doing this I lost the front right speaker and the rear passenger speakers. Only thing I can think of is there is now an open circuit that must have looped through the cb board in order to close it? Any thoughts? Need to find a wiring diagram to see what wires need to be tied together to close the circuit again? Any help would be great!
Thread
Thread Starter
Forum
Replies
Last Post
