I purchased Billet Engine Guard Footpeg Mounting Kit P/N: 50957-02B. It came with some spring washers that are apparently P/N: 50912-72. I am unable to place my Streamliner pegs into the mounts with the spring washers. Is there a trick to this? Are the spring washers even necessary? This shouldn't be this difficult.

The instructions are here: http://www.harley-davidson.com/en_US...ts/-J02458.pdf

Thanks,
mikebaby

 

Just have to work 'em in. If you don't use the spring washers, the pegs won't have any tension on them. Just my experience.....

 

yep, had the same problem, just work them end, rounded edge first.

 

I finally got them in, but they were really REALLY tight. So I took them back out and added some grease, and forced them back in again.

Thanks for the help guys!

mikebaby

 

Am I the only one that laughed when I read this last post?

 

NO.... lol