What did you do to your bagger today?
#6502
Yes sir I did.
Got the head pipe swapped out - nice increase in sound (currently running Klock Werks Super Savers) Heat wasn't an issue - short test run and cooler temps. Now to get a new PCV map from Fuel Moto.
Got the head pipe swapped out - nice increase in sound (currently running Klock Werks Super Savers) Heat wasn't an issue - short test run and cooler temps. Now to get a new PCV map from Fuel Moto.
#6504
Actually it was yesterday, but at the dealer, picked up my Mustang Vintage Solo seat w/built in backrest. They installed LED rear tail lights and turn signals. They are "run", "brake", "turn". Also had them install Streamliner grips to match the rest of the foot boards and pegs.
The color on the close up of the new lights is a little orange - bad lighting and I had a broom in one hand pressing on the rear brake while taking the picture with the phone camera
A few pics attached.
The color on the close up of the new lights is a little orange - bad lighting and I had a broom in one hand pressing on the rear brake while taking the picture with the phone camera
A few pics attached.
#6505
Actually it was yesterday, but at the dealer, picked up my Mustang Vintage Solo seat w/built in backrest. They installed LED rear tail lights and turn signals. They are "run", "brake", "turn". Also had them install Streamliner grips to match the rest of the foot boards and pegs.
The color on the close up of the new lights is a little orange - bad lighting and I had a broom in one hand pressing on the rear brake while taking the picture with the phone camera
A few pics attached.
The color on the close up of the new lights is a little orange - bad lighting and I had a broom in one hand pressing on the rear brake while taking the picture with the phone camera
A few pics attached.
#6506
Finally got the lower speaker pods mounted and speakers installed, replaced the amplifier and made a bracket to hold it in place rather than ripping two square feet of velcro apart every time, and wired in the speaker switch and harness pins for two 1/8" jacks to plug our helmet speakers into.
Now to buy the pieces necessary to add the volume switch for the rear speaker pod so she can actually turn the headset volume up lol.
Now to buy the pieces necessary to add the volume switch for the rear speaker pod so she can actually turn the headset volume up lol.
#6509
Took the day off and installed a tour-pak rack, BAL-1 tail light, and RAM Mount cup holder. Last week I had A CB installed, which required new handlebar controls, so I had them throw on the Avon Air Cushion grips...Switched out the antenna(s) so there both "Shorty's"
Ready to ride to the mountains!
Ready to ride to the mountains!