What did you do to your bagger today?
That is a good lookin scoot! You've done some amazing work to it. You do us MD boys justice. Even though I'm in VA I'm born and raised in Baltimore.
The following users liked this post:
Bafflingbs (09-28-2022)
Thank you, sir!
Looks great as always!
The following 2 users liked this post by NorthWestern:
Bafflingbs (09-29-2022),
Oil, Gas & Leather (09-29-2022)
The following 3 users liked this post by wilburbill:
Last edited by Bafflingbs; 09-29-2022 at 07:25 PM.
The following 2 users liked this post by Bafflingbs:
bson (09-30-2022),
JED POLAND (09-30-2022)
Got my Chopped AdvanBlack Tour-Pak assembled after work! Unfortunately it's dark so I'll check it out on the bike tomorrow during daylight.
Ordered a cheapo rubber mat off Amazon, just to keep contents from getting stuck in the wiring. Like bag straps and stuff. I don't really want a padded liner.
Ordered a NAMZ power outlet, should be plug-and-play with the 6-pin connectors on the harness. I'll plug a USB charger into it.
Ordered the Kemimoto side organizers off Amazon. I will probably only use one, on the short side next to the wire harness, just to have something to hold my phone and a few minor odds and ends.
Apologies for the crappy light... I was using a DeWalt flashlight for illumination.
Ordered a cheapo rubber mat off Amazon, just to keep contents from getting stuck in the wiring. Like bag straps and stuff. I don't really want a padded liner.
Ordered a NAMZ power outlet, should be plug-and-play with the 6-pin connectors on the harness. I'll plug a USB charger into it.
Ordered the Kemimoto side organizers off Amazon. I will probably only use one, on the short side next to the wire harness, just to have something to hold my phone and a few minor odds and ends.
Apologies for the crappy light... I was using a DeWalt flashlight for illumination.
Last edited by bson; 09-30-2022 at 12:23 AM.
The following 5 users liked this post by bson:
426power (09-30-2022),
Bafflingbs (09-30-2022),
chopr147 (10-04-2022),
Oil, Gas & Leather (10-04-2022),
V8R (09-30-2022)
Works great! Since it's all LED in the rear I can add or remove it at will, without having to retrain the BCM. Super happy with the look!!!
Love it!
Don't love the mounting bracket though - the spacing is WAY off. Will have to ping AdvanBlack about this, but most likely I'll just order an OEM bracket.
Left:
Right:
Sure I could try to bend it (it doesn't look particularly square), but who knows what kind of warpage I end up with. Pass. I'd rather just use a part that fits right from the start.
Love it!
Don't love the mounting bracket though - the spacing is WAY off. Will have to ping AdvanBlack about this, but most likely I'll just order an OEM bracket.
Left:
Right:
Sure I could try to bend it (it doesn't look particularly square), but who knows what kind of warpage I end up with. Pass. I'd rather just use a part that fits right from the start.
The following 2 users liked this post by bson:
Bafflingbs (10-01-2022),
johndoe297 (09-30-2022)
Ok, not meaning to insult you, but are you sure you have them on correct sides, ie left only and right only? Just throwing it out there.