What did you do to your bagger today?
No use of skulls on anything. never understood it on Harleys but to each you own. Oh so that is political. So ban me thought police.
The following users liked this post:
Oil, Gas & Leather (01-11-2021)
The following 4 users liked this post by SWFLGuy:
Join Date: Apr 2020
Location: Southern Coast o' Maine ON DA BEACH!
Posts: 1,802
Received 643 Likes
on
461 Posts
22xe cam, fm pushrods, s&s tappet cuffs, alpha rollers lifters, 8 lobe oil pump, new bearing.....rode 20 miles in 25* temps....oh man, what a ride it was. 107 motor, Rinehart dbx 4.5 with baffles and DK torque inserts, stock decated header, fp3 with a modified map for the 22xe cam...seemed right on. From a stop the bike seemed like its on steroids now.... thanks to Fuel Moto for a great deal on the kit and overnighting the tappet cuffs this week. A Complete wash and wax after the ride to get all the winter grime and salt off the bike. I can't wait for spring!
....and I forgot to mention the lope at idle is outstanding and the bike sounds incredible.
....and I forgot to mention the lope at idle is outstanding and the bike sounds incredible.
The following users liked this post:
ChromeRose83 (01-12-2021)
Join Date: Apr 2020
Location: Southern Coast o' Maine ON DA BEACH!
Posts: 1,802
Received 643 Likes
on
461 Posts
Thanks my fellow patriots/Americans! *** DELETED - Pls Keep Political Comments ONLY In The POD *** Onwards & upwards!
Last edited by BuzzCap7; 01-11-2021 at 12:39 PM. Reason: Political.
Join Date: Apr 2020
Location: Southern Coast o' Maine ON DA BEACH!
Posts: 1,802
Received 643 Likes
on
461 Posts
What brand heated gear? I just bought GOBI HEAT jacket & gloves. About $170.00 each and worth every penny. Rechargeable batteries run em. Three levels of heat choices controlled by a lighted button. They're da bomb in cold weather!
My personal taste only, but I am not a fan of the "slammed" look, on cars or bikes. My problem, is I don't have the inseam length to support my preferred setup. I got away with 13" rears and 2" over on my XL1200L, but actually had to put 1" lowering blocks on my Classic. I think its the much wider seat and engine on the bagger.
I like the look of yours. Plus an added bonus, is greater lean angles sre now possible. The extra travel with progressive coils will help the ride quality too.
The following 2 users liked this post by handirifle:
DynaKid94 (01-11-2021),
Oil, Gas & Leather (01-11-2021)
Join Date: Apr 2020
Location: Southern Coast o' Maine ON DA BEACH!
Posts: 1,802
Received 643 Likes
on
461 Posts
Outstanding! Mine's also a 2019, but only 8K miles. But since I was going in, figured I'd just do it all! Tensioner & cuffs were only about $70 each. Enjoy!
I got the full Hotwired setup. 2yr warranty and no question exchanges at any cycle gear if I have any problems. Added bonus.
Tonight's project... carbon fiber bar and shield install. Got some additional carbon stuff on order but it will be a few weeks before it shows up. Lovin how these look. Pricy little bastards but forgot about that once I taped them up for mockup.
The following 3 users liked this post by bunk216: