I have a friend with s pre-rushmore bike, and are you saying its a direct swap for the bags? So if someone gets a set of rushmore bags and lids, they fit without mods?

 

LRS Shield (Stingray - medium tint - 10")

 

Agreed! I don't even open my '09 saddlebags. Everything goes in the tourpak. Too much hassle.

 

Ordered the fairing spoilers and chopped engine guard from Surdyke.

 

From what I understand, you just have to slot the front mounting bracket if at all, and they will basically bolt on to anything from 93 and up with a little mount modding.

 

will these bags fit inside my Ultra classic chrome guards or will I have to take them off and get the supports that goes with these bags.

 

Hooked up battery charger for two months due to knee surgery 😢

 

I just looked up the River Run because I've been wanting to do that and it says it's been canceled. Unless you're doing your own type of River Run. hahaha!!

 

FINALLY! Finished my fork upgrade. Installed Suspension Technologies cartridges. Changed the sliders and cow bells to black. Leaving the fender off for now. I have a fab guy going to cut my fender to make it a shorty and then going to wrap it. Pretty much done with all the major upgrades now. Now I can enjoy the rest of the summer. I didn't get a chance to ride it after buttoning everything up. Barely had time to screw the cow bells on before I went to work. Once I take it for a decent ride to get a feeling for it I'll post up a review.

 

No they will not just fit right up. You will need to make a modification. But its to easy. So the mounting holes are off just a bit. Like less than 1 inch in either direction. So you can use one of the holes as your start, which ever you choose the other hole you will have to drill a new hole and move your gromet that half and inch. I didnt have to change any of the bag rails or anything else. All you'll need is a drill and a set of bits