What did you do to your bagger today?
installed a few goodies over the weekend on my new to me, 2016 Street Glide Special, did a Hogworkz halomaker headlight, Klock Werks 6.5" flare shield, led signals, and smoked lenses, then today, I installed RSD levers, and Avon memory foam grips
The following 4 users liked this post by scott_0:
Oil, Gas & Leather (06-30-2020),
slippin_jimmy (06-30-2020),
tn_popo (06-30-2020),
WristpinKnock (07-01-2020)
Got an email from FedEx. They have my cam kit from Fuel Moto. It should be here Wednesday...........
The following users liked this post:
Oil, Gas & Leather (06-30-2020)
Last edited by barneyboy; 06-29-2020 at 05:53 PM.
hrmmm these are the thinner diamater ones, but I will have to check and verify...
Being thinner, they should. I put a pair on the King when I did a bar job. Very comfy.
Replaced the awful Rockford Fosgate 6.5s with some Mmats 6.5s. Had to cut the speaker pods a bit but I covered that with some sound defending. Mmats sound SO much better. Did not get a finished picture...lame.
The following users liked this post:
crtman21 (06-29-2020)
Got all my new PC parts on. Some before and after. Except the dash. You know what they say? "Once you go black..." LOL!!
fabbed up a external breather setup, used two 10-32 grub screws to plug the filter backing plate, two 1/8" npt to 1/4" barb fittings, a 1/4" barb T fitting, 6ft of 1/4" fuel line, and a small filter from amazon (will arrive tomorrow) I ran line down the right side of the bike and zip tied to the frame, where it ends just in front of the exhaust. I'll post pics of the finished product tomorrow. Then I put a reflective flag decal on the trans cover, the plain chrome vastness was annoying me lol. Then I got some good quality miles in, getting to know the bike, I am absolutely loving it, it has made forget all about my Wide Glide!
Last edited by scott_0; 07-01-2020 at 02:43 PM.
Looked over the maint schedule for my bike. Its recommended to rebuild front forks at 50k, and since my front end does not seem totally right, AND I am getting the steering head bearings replaced Friday, under warranty, I decided to have them do the forks as well. Will cost me an extra $380 but this saves me about 1.5hrs labor, since the front end will be apart for the head bearings anyway.
Was hoping not to have to have the dealer do much out of warranty work, but I would need tools I do not have, and would mean a lot of down time for the bike. The dealer I bought the bike from replaced the front wheel bearings, before the sale, so my front end will be like new.
That will be a big burden taken care of. Probably never have to do it again. Just wish that could be under warranty too.
Was hoping not to have to have the dealer do much out of warranty work, but I would need tools I do not have, and would mean a lot of down time for the bike. The dealer I bought the bike from replaced the front wheel bearings, before the sale, so my front end will be like new.
That will be a big burden taken care of. Probably never have to do it again. Just wish that could be under warranty too.