OK, tried posting this in the Electrical section & got zero answers, so figured I'd try it here. (Hopefully posting it twice won't make the Mods mad...)

Before going to the dealer (30 miles away) I figured I'd try posting this here on the off chance someone can help...

Getting a "B1124(HFSM) Right Turn Output Short to Ground" DTC. RH turn signal doesn't work- anyone know how to fix this? Fuses are good, no obvious shorts anywhere...
Thanks.

 

If you have the manual w/wiring diagrams you could check to see if the switch is grounded. If you have changed the bars and used extensions you should check to make sure nothing has "rubbed" through. If you haven't changed anything then the most likely culprit is the switch.

 

Havent changed the bars, but will look at the electrical manual & see what it says. Thanks.