Radio Shack - Alarm Siren Install - 2011 RGC
#51
Wachuco,
Thanks for the great tip! I picked up the parts at Radio Shack and installed mine tonight. Works perfect. Only thing I did differently was to use my dremel to make a hole through the back side of the dummy socket so I could push the connector back into place with no visble wires, shrink tubed each wire then siliconed the hole.
Thanks again for the inesxpensive alternative to Harleys $100 siren!
Thanks for the great tip! I picked up the parts at Radio Shack and installed mine tonight. Works perfect. Only thing I did differently was to use my dremel to make a hole through the back side of the dummy socket so I could push the connector back into place with no visble wires, shrink tubed each wire then siliconed the hole.
Thanks again for the inesxpensive alternative to Harleys $100 siren!
#58
#59
Yep, same here. Don't go out and move the bike without the FOB handy or it will scream at you until you go get it. Loud in an enclosed garage.
#60
Wait..I understand the need for the male pins , connection etc..etc...but why a 9 pin connector. Why not buy the applicable molex ( I think its called ) connector from HD. It's like 6 dollars then run your wireing and wallah..why buy a 9 pin for a 3 pin connection. I .probably sound like I belong on a short yellow bus with a larger helmet , but my connector doesn't seem to need a 9 point set up