HD LED Taillight
#22
02-28-2011, 11:27 PM
Thanks for the great info. I will be purchasing a BAL-1 when I return to the states. I talked to a couple Italian friends who are Carabinieri (national cops), they said that when traveling outside my area, it would bring attention to me, meaning I would get pulled over, they are pretty cranky about flashing lights on non-official vehicles. Anyway, long story short, the HD light is only $109 through Zanottis, they were nice enough to add it to my current order, so no extra shipping. As I said, when I get back to the states, I will pull the trigger on it. I am lucky, I can sell the taillight I just bought to a buddy when I leave, that way, it won't seem like a $200 part to my wife. 
Thanks again everyone.
Thanks again everyone.
#24
03-03-2011, 10:16 PM
#25
03-04-2011, 12:12 AM
Road Warrior
#26
03-04-2011, 07:21 AM
#27
03-24-2011, 08:36 PM
Road Warrior
I got the HD unit for my SG. I really like the look - but it was a PITA to get on. The wires had little or no where to go - so they were pinching the between the light housing and the fender plug block. This kept the light from really sealing around the out side edges to make it water tight.
After 20 mins of dickin' with it I had to hack the inside ribs of the new light back to make room - not too cool.
After 20 mins of dickin' with it I had to hack the inside ribs of the new light back to make room - not too cool.
#28
03-24-2011, 10:01 PM
I got the HD unit for my SG. I really like the look - but it was a PITA to get on. The wires had little or no where to go - so they were pinching the between the light housing and the fender plug block. This kept the light from really sealing around the out side edges to make it water tight.
After 20 mins of dickin' with it I had to hack the inside ribs of the new light back to make room - not too cool.
After 20 mins of dickin' with it I had to hack the inside ribs of the new light back to make room - not too cool.
#29
03-25-2011, 07:07 AM
I got the HD unit for my SG. I really like the look - but it was a PITA to get on. The wires had little or no where to go - so they were pinching the between the light housing and the fender plug block. This kept the light from really sealing around the out side edges to make it water tight.
After 20 mins of dickin' with it I had to hack the inside ribs of the new light back to make room - not too cool.
After 20 mins of dickin' with it I had to hack the inside ribs of the new light back to make room - not too cool.
Thread
Thread Starter
Forum
Replies
Last Post
