pinstripe on my SG
#22
#23
Hey HOMBRE2011,
Welcome to the forum.
Here is contact info for outlaw graphics as posted in the thread, if you have any questions I am sure Jason will answer them.
here is Jasons email addy okoutlaw1975@yahoo.com
and a link to ebay http://shop.ebay.ca/jwmac75/m.html
I have applied decals in the past and it was quite simple-(wet method) I used a mixture of a little dish soap and water moved the deals into place used a small plastic scraper to remove access water/air bubbles and let dry.
Jason advised me the pinstrip kit does come with directions.
hope this helps
Colin
Welcome to the forum.
Here is contact info for outlaw graphics as posted in the thread, if you have any questions I am sure Jason will answer them.
here is Jasons email addy okoutlaw1975@yahoo.com
and a link to ebay http://shop.ebay.ca/jwmac75/m.html
I have applied decals in the past and it was quite simple-(wet method) I used a mixture of a little dish soap and water moved the deals into place used a small plastic scraper to remove access water/air bubbles and let dry.
Jason advised me the pinstrip kit does come with directions.
hope this helps
Colin
Last edited by Colin1966; 02-15-2011 at 08:42 PM.
#27
Hey HOMBRE2011,
Welcome to the forum.
Here is contact info for outlaw graphics as posted in the thread, if you have any questions I am sure Jason will answer them.
here is Jasons email addy okoutlaw1975@yahoo.com
and a link to ebay http://shop.ebay.ca/jwmac75/m.html
I have applied decals in the past and it was quite simple-(wet method) I used a mixture of a little dish soap and water moved the deals into place used a small plastic scraper to remove access water/air bubbles and let dry.
Jason advised me the pinstrip kit does come with directions.
hope this helps
Colin
Welcome to the forum.
Here is contact info for outlaw graphics as posted in the thread, if you have any questions I am sure Jason will answer them.
here is Jasons email addy okoutlaw1975@yahoo.com
and a link to ebay http://shop.ebay.ca/jwmac75/m.html
I have applied decals in the past and it was quite simple-(wet method) I used a mixture of a little dish soap and water moved the deals into place used a small plastic scraper to remove access water/air bubbles and let dry.
Jason advised me the pinstrip kit does come with directions.
hope this helps
Colin
#28
this is from past experience,
from what I understand each decal will come on a sheet it will have a backing sheet,(example fender) apply water mixture remove the backing sheet move decal into place apply presure from the scraper while removing the top sheet leaving the decal on the fender.
Colin
check this out
http://www.mysticker.co.nz/documents..._Decal_FAQ.pdf
from what I understand each decal will come on a sheet it will have a backing sheet,(example fender) apply water mixture remove the backing sheet move decal into place apply presure from the scraper while removing the top sheet leaving the decal on the fender.
Colin
check this out
http://www.mysticker.co.nz/documents..._Decal_FAQ.pdf
Last edited by Colin1966; 02-15-2011 at 09:16 PM.