EVO Remove & Twin Cam It ??
#1
EVO Remove & Twin Cam It ??
Simple question but the answer might get complicated. I have been thinking of getting a 1998 EG w/EVO motor , only has 27K miles , Bike is like a New penny , never have seen a mint old bike like this one, It was taken care of for a long time. I have been told by many in this Forum that when you go to make an EVO quicker because of the Fuel Injection (MM Injection ) it does not take to engine changes(cam- valves -rocker work ?) but Exhaust or Air intake was fine and NO PROBLEMS . Can I put in a twin or a 103-110 or any Twin engine that is a done up engine and will it just fit in OR will it not at all and I must stay with the EVO ?
#3
#7
A '98 EVO w/27K !!
Hell, That motor doesn't hardly have the rings set yet!!!
EVO's are strong old motors. They respond very well to any 'normal' mods (cam, compression, displacement, A/C, exhaust, EFI tuner, etc.). Some have experienced problems with lower base gaskets, but mine are still holding.
I have a 'warmed over' '88 with lots of enjoyed miles on it and am looking forwared to many more. It has a lot more 'snap' than my '05 T/C!!
EVO's are strong old motors. They respond very well to any 'normal' mods (cam, compression, displacement, A/C, exhaust, EFI tuner, etc.). Some have experienced problems with lower base gaskets, but mine are still holding.
I have a 'warmed over' '88 with lots of enjoyed miles on it and am looking forwared to many more. It has a lot more 'snap' than my '05 T/C!!
Trending Topics
#8
#9
#10