Modified Air Cleaner (Football) Cover
#22
link for the flame cutout cover for those that asked
http://www.microfiber-products-onlin...aflcuairc.html
http://www.microfiber-products-onlin...aflcuairc.html
#23
#25
Funny, you have to agree with everyone's comments! I mean, it looks unfinished, the ugly parts show, it's unique, it's like all of the above.
I will say that the bolt is really only visible if you get down to it's level, otherwise you don't see it.
In it's current state though it doesn't strike me as I had hoped it would. I don't mind oneoffness and unique but if it doesn't look like a pro job then it may look like sheeeeettt!
Cutting it round with a sock probably wouldn't look bad, I like that look. Removing the matching cutaway on the front side might not be too bad or, it may look like sheeeettt too.
I'll sit on it for a while and see what happens. Like I said, gave it a shot, was just thinking outside of the airbox.
Thanks for all the comments and appreciate any more
I will say that the bolt is really only visible if you get down to it's level, otherwise you don't see it.
In it's current state though it doesn't strike me as I had hoped it would. I don't mind oneoffness and unique but if it doesn't look like a pro job then it may look like sheeeeettt!
Cutting it round with a sock probably wouldn't look bad, I like that look. Removing the matching cutaway on the front side might not be too bad or, it may look like sheeeettt too.
I'll sit on it for a while and see what happens. Like I said, gave it a shot, was just thinking outside of the airbox.
Thanks for all the comments and appreciate any more
#26
........... i agree w/ya, but tell that to the guys walkin'round @ bike nite.
..... nice take on modding the cover, but that back cut looks pointy & sharp to me. Wouldn't wanna bump a knee too hard into it when maneuvering the scoot in a tight place.
..... nice take on modding the cover, but that back cut looks pointy & sharp to me. Wouldn't wanna bump a knee too hard into it when maneuvering the scoot in a tight place.
#27
#28
#30
I like that one RocknRod that you have, I agree on the good lines of following the engine. I thought about that cut but it would have left the front open like I tried to avoid on this.
I wish I had a few more to operate on and see what I could come up with but I have to admit, my custom job here is growing on me.
I think I'll run it for a while. I guess as long as kids don't throw rocks at me and mothers don't pull their kids off the street when I come by maybe it won't be too bad
I wish I had a few more to operate on and see what I could come up with but I have to admit, my custom job here is growing on me.
I think I'll run it for a while. I guess as long as kids don't throw rocks at me and mothers don't pull their kids off the street when I come by maybe it won't be too bad
Thread
Thread Starter
Forum
Replies
Last Post