Torque Wrench
#1
Torque Wrench
There is another thread that I started concerning changing the transmission fluid. After checking my Owner's Manuel, I see that you are supposed to tighten the drain plug bolt between 14-21 ft lbs. Well, I don't own a torque wrench; and have simply gotten by with minor repairs and such by tightening according to "feel." However, it occurs to me that you want to be careful not to under tighten the drain plug (so as to avoid leaking) as well as over tighten and possibly snap off the bolt. So, before I run off to Harbor Freight or the Home Depot, can someone recommend the type of torque wrench I should get, understanding that I'm not a professional mechanic, and I am only going to perform minor repairs and maintenance. Therefore, I don't need the best/most expensive torque wrench. Thanks in advance.
#2
Im not a professional tool man by any means, but I would recommend staying away from harbor freight for precision tools like torque wrenches and gauges. I would pay the little extra money and get a tool with a lifetime gaurentee, i.e. Craftsman, Snap-on, Duralast. Just my two sense.
Im not bashing harbor freight, Ive got a ton of tools from there that are one time use pieces. Anything you use often you should spent a little more jack on.
Im not bashing harbor freight, Ive got a ton of tools from there that are one time use pieces. Anything you use often you should spent a little more jack on.
#4
Im not a professional tool man by any means, but I would recommend staying away from harbor freight for precision tools like torque wrenches and gauges. I would pay the little extra money and get a tool with a lifetime gaurentee, i.e. Craftsman, Snap-on, Duralast. Just my two sense.
Im not bashing harbor freight, Ive got a ton of tools from there that are one time use pieces. Anything you use often you should spent a little more jack on.
Im not bashing harbor freight, Ive got a ton of tools from there that are one time use pieces. Anything you use often you should spent a little more jack on.
#5
Nothing wrong with the Harbor Freight torque wrench. I have 2, a 3/8 and 1/2 drive. Never any issues with them, they work fine. Minor stuff you should be able to get by with the 3/8 drive torque wrench that I believe goes between 0 and 50 ft. lbs. If you want to torque an axle nut you will need to get the 1/2 drive that goes up to 100 ft. lbs. Someone did some comparisons on torque wrenches and the Harbor Freight one's were calibrated very well.
#7
Trending Topics
#8
FWIW, I am new to wrenching on bikes and when I went to buy a torque wrench, the advice I got from the salesman was not to buy the one that looks like a socket wrench that you dial in the desired toque - but instead he recommended the one with a needle - his reason was that the dial-up ones are not as accurate and need to be re-calibrated often, whereas the one with a needle is much more accurate.....don't know the truth behind it all, but I bought the needle one and it seems to work fine - except, in some positions, it is difficult to read the specs as you are wrenching because the numbers are only on one side.
#9
If you purchase a ratchet type torque wrench that clicks at the set ft pound it may be off,additionally they should be calibrated annually.With that in mind I would recomend a non ratchet type wrench with a bar for reading the torque.This way you will always know if it is off and be able to adjust for it when you use it!
#10