Chose my engine builder..Throttle-City
#21
06-20-2010 | 07:33 AM
Ultimate HDF Member
Joined: Jun 2010
Posts: 6,066
Likes: 1,280
From: OH, USA
No Problem..
I know Larry worked for Simons, Related to him? I dont know. But I'd steer clear of Larry too.. He just blew up an customers bike that was a 1 off S&S custom built.. Guy asked for his bike back and said he'd send Larry the Bill. Larry wouldnt so the guy and some "Friends" had to got take it back.
Shame everyone want to be a builder so why not just be good at what you do and treat people right.
I like DP Cycle in Philly, Dons a good guy.. Just no Dyno. He sends his bike to Simons for that.
I just put a Rinehart 2-1 and a PC-V Stagie 1 AC on my bike. Runs killer with Map sent but I'm gonna get it tuned.. At Simons.
I know Larry worked for Simons, Related to him? I dont know. But I'd steer clear of Larry too.. He just blew up an customers bike that was a 1 off S&S custom built.. Guy asked for his bike back and said he'd send Larry the Bill. Larry wouldnt so the guy and some "Friends" had to got take it back.
Shame everyone want to be a builder so why not just be good at what you do and treat people right.
I like DP Cycle in Philly, Dons a good guy.. Just no Dyno. He sends his bike to Simons for that.
I just put a Rinehart 2-1 and a PC-V Stagie 1 AC on my bike. Runs killer with Map sent but I'm gonna get it tuned.. At Simons.
#22
04-17-2012 | 04:02 PM
Dropped the bike off to Chuck at Throttle-City today and pick it up next Saturday. Hopefully the weather will co-operate so I can get some riding time with the 103.
NJ guys. This shop is located off the first exit on the PA turnpike. You go over the bridge through the toll and get off almost immediately. It is then a 5-10 minute ride. Very easy to get to......
NJ guys. This shop is located off the first exit on the PA turnpike. You go over the bridge through the toll and get off almost immediately. It is then a 5-10 minute ride. Very easy to get to......
Thread
Thread Starter
Forum
Replies
Last Post
