Just wanted to update you all on my Hillside/Wood's 103 build. Heads are torqued, lower rocker boxes are ground to allow for .060 clearance for valve springs and spring collars, rockers installed and pushrods are adjusted. Tomorrow, it's TFI and exhaust install and then a turnover w/out plugs installed to check for funny noises. Here's a few pics of my progress (rocker pics didn't turn out very well...sorry) . I've included a picture of my bride with her Valentines Day gift....a new SE Compensator sprocket. She was THRILLED!!!!! LIFE IS GOOD!

 

Damn, I was ready to go to bed, then I ran across this thread and I'm wide awake. Much better than the crap on T.V..

 

Nice! I like the looks of were this is going.
Is that intake a bigger valve?
Very nice work!! What ever happend to this build? did you finish?

 

Yep, finished the build quite some time ago. Bike runs like a raped ape. Pulls incredibly hard from 3K to 5+. Switched my supertrapp pipes for some V&H power duals and high output slip-ons and it's even better. The Hillside heads & Woods cams are great. Really happy with the way this bike runs.

 

so where is the dyno sheet??????????

 

I oils like to see the sheet too. Also how's tthat compensator. I know my stocker makes noise ever since the cam install. Do you get any noise from the se compensator?