Hillside Cycle/Woods 103" project
#51
Just wanted to update you all on my Hillside/Wood's 103 build. Heads are torqued, lower rocker boxes are ground to allow for .060 clearance for valve springs and spring collars, rockers installed and pushrods are adjusted. Tomorrow, it's TFI and exhaust install and then a turnover w/out plugs installed to check for funny noises. Here's a few pics of my progress (rocker pics didn't turn out very well...sorry) . I've included a picture of my bride with her Valentines Day gift....a new SE Compensator sprocket. She was THRILLED!!!!! LIFE IS GOOD!
#54
Yep, finished the build quite some time ago. Bike runs like a raped ape. Pulls incredibly hard from 3K to 5+. Switched my supertrapp pipes for some V&H power duals and high output slip-ons and it's even better. The Hillside heads & Woods cams are great. Really happy with the way this bike runs.
#55
Yep, finished the build quite some time ago. Bike runs like a raped ape. Pulls incredibly hard from 3K to 5+. Switched my supertrapp pipes for some V&H power duals and high output slip-ons and it's even better. The Hillside heads & Woods cams are great. Really happy with the way this bike runs.
#56
Thread
Thread Starter
Forum
Replies
Last Post
Bafflingbs
Dyno Charts
0
03-09-2017 01:01 AM
Buckinfitch
Touring Models
78
04-25-2014 10:07 PM