I'm upgrading my wife's '09 SE Road Glide to have a CB. I'm looking to buy the left hand control assembly with the PTT button. I found the following part number, but its not pulling up on Zanotti or Chicago HD's website. Before I call, I wanted to make sure this is the correct part number for just the control switch housing.

Thanks for your help.

70046-07 Handlebar control assembly, left hand

 

I suspect its the same as on '07s. Part No in my book is 77100-98

 

Is that part number just the bottom portion of the switch assembly? Looks like it is the Squelch and PTT button - not sure how that is going to work in to the wiring harness, but I'll give it a shot.

 

71594-98A lower switch housing
71735-08 PTT switch assembly
71642-08 audio control switch assembly

 

Thanks for the help guys. Looks like I have the right parts for this. Now I just have to figure out how to wire the PTT switch in to the existing harness. I'm assuming there are some open pins, and that the wiring is covered in the service manual.

 

I added a PTT switch to a buddy's bike (he added CB to his Classic) a couple of years ago and the switch didn't come with wire or terminals.

If the PTT you bought doesn't have the wire terminals, the p/n is 72169-07. The SM has wiring diagrams and pin location numbers so the wires go in the correct slots in the connector, and information on how to assemble the Molex connector in the Appendix. A good rule of thumb is that the wire colors match between the male and female connectors when correctly assembled and connected.