This might be one for Dawg.I'm looking for the part # for the original rear turn signal bar on an 09 Road King.It is the one that has the LED lights for the license plate and the mounting points for the plate bracket.It is not the narrow bar like on the Street Glide.
Thanks for any info.
Dan.

 

I am looking for the same thing. It has the license plate light built into it and if we could find it could move the license plate bracket under it and have illumination. I had them to try to find it at the HD dealer but they said it wasn't available. What if somebody had a wreck, wouldn't they be able to replace it?

 

Yeah,it seems to be a rare piece,but the Road King and the EG Standard both have it.When I remove my tour pac I want to put my plate below my tail-light,and this is a nice looking bar,but it is a tad narrower than the stock EGC bar.

 

Its narrower? I find that hard to believe, the one that was stock on my RK was HUGE!!! I switched to the Street Glide bar. The only thing I liked more about the RK bar is the licence plate lamp is LED, the one I have now is a halogen bulb

 

Hi Brett,is there a part # on your old bar?

 

Subscribed I'd like to know too. I've seen a few for sale on ebay etc but no part number. I for one like the big pancakes signals on back more visibility the better.

 

Not sure, when I go out to feed the dogs, I will check for you

 

thanks

 

I don't like the narrow "Bullet" style on my Road Glide. I wanted to go to the "Popsicle' Turn Signal on the rear. I tried to get these for my Road Glide, but the cost was high. I elected to use one without the expanded area for the LED License Light. I made a License Plate Bracket that mounted to the Turn Signal Bar bolts and used Kuryakyn LED Light Bolts.

I have the Part Catalog for my 2009 Touring Models.

The part number is 68742-09 for the Bar used on the FLHR, FLHTC, FLHTCU, and FLHT models. The License Light number is 69378-09.

 

You guys talking about this one? 68143-98A
It has the LED lights built into the bar.