**TOURING HANDLEBARS**Wild One WO508, 518, 513, 515, 502 - Handlebars
#392
Wild1 Chubbys......
Just put a set of 515 bars on my road king. 10" baby apes. seem comfortable. have to get an extended brake line and longer wires for the switches. cables work fine . ordered a 6" longer line... hope it's not too long. didn't know if i should go with a 4" or 6". can't ride until i do all this. line to be here next week....waw,lol.
#393
#397
New bars
Hi folks,
I'm in the process of switching out the stock handlebar to a Carlini, but I'm having trouble with the switch housings spinning on the bar ends after I've tightened them down. Any ideas as to what I might have done wrong, and how to cure the problem?
Thanks for your help.
I'm in the process of switching out the stock handlebar to a Carlini, but I'm having trouble with the switch housings spinning on the bar ends after I've tightened them down. Any ideas as to what I might have done wrong, and how to cure the problem?
Thanks for your help.
#398
New bars
Hi folks,
I'm in the process of switching out the stock handlebar to a Carlini, but I'm having trouble with the switch housings spinning on the bar ends after I've tightened them down. Any ideas as to what I might have done wrong, and how to cure the problem?
Thanks for your help.
I'm in the process of switching out the stock handlebar to a Carlini, but I'm having trouble with the switch housings spinning on the bar ends after I've tightened them down. Any ideas as to what I might have done wrong, and how to cure the problem?
Thanks for your help.
#399
#400
I purchased Carlini 14'' 1.25'' flying apes and they sent me your cable/line kit...LA-8010 B13...is this correct for a 09 FLHRC?
I can not seem to get the round chrome 3 way splitter to line up cuz of the offset pin to hold it in place...assuming the recessed part goes up...tried both ways.
I can only find this pic for older models when i search...07 and older.
Also that part # never shows up anywhere.
I can not seem to get the round chrome 3 way splitter to line up cuz of the offset pin to hold it in place...assuming the recessed part goes up...tried both ways.
I can only find this pic for older models when i search...07 and older.
Also that part # never shows up anywhere.