Looking for ideas for new products...
#21
#22
I'll put a thread in the softail section too, but you can post in this one. So far the guys I ride with want quick release brackets for hardbags for a softail, Under the taillight relocation bracket with a nice curve in it for a heritage, Quick release brackets for a Dyna for saddlebags that are able to be used without relcoating the signals, Bar mounted cigarette lighter, and the list goes on. I gotta write this all down as I cannot remember everything people suggested today.
#23
#24
Wider Floor Boards Extenders.
I had an 07 Fat Boy that I bought floor board extentions off of you and they hooked up between the bracket and the board and was 1 1/2" wide.
I bought your Touring model and they are only 7/8" wide and fit between the frame and the bracket.
What's up with the difference?????
I had an 07 Fat Boy that I bought floor board extentions off of you and they hooked up between the bracket and the board and was 1 1/2" wide.
I bought your Touring model and they are only 7/8" wide and fit between the frame and the bracket.
What's up with the difference?????
#26
Wider Floor Boards Extenders.
I had an 07 Fat Boy that I bought floor board extentions off of you and they hooked up between the bracket and the board and was 1 1/2" wide.
I bought your Touring model and they are only 7/8" wide and fit between the frame and the bracket.
What's up with the difference?????
I had an 07 Fat Boy that I bought floor board extentions off of you and they hooked up between the bracket and the board and was 1 1/2" wide.
I bought your Touring model and they are only 7/8" wide and fit between the frame and the bracket.
What's up with the difference?????
#27
#28
#29
How about a better passenger extended foot pegs for the Ultra Classic that is better than what Kuryakyn has as theirs has a bolt that sometimes work loose and when doing stop and go in traffic the back of my leg hits the footpeg. I tried the one from SoftBrake and I stripped out the bolts that hold the bottom clamp on, I had them tap out and put in bigger bolts, but the one on the right will not tighten up unless I shim up the bottem clamp.