2002 Ultra 95" Dyno on Nitrous
#1
04-21-2009 | 05:48 PM
Thread Starter
|
Advanced
Joined: Oct 2008
Posts: 65
Likes: 0
From: Winston - Salem Greensboro area North Carolina
2002 Ultra 95" Dyno on Nitrous
I finally finished my wife's engine upgrade a couple of months ago. I have installed a wet nitrous prototype system that I've been developing for while.
I mapped it after it had enough miles. I took it to a local Harley dealer to have it dynoed. I always have an independent dealer or tuner to dyno the bike so that I have no influence on the dyno results.
The build is typical (non-radical): Big bore w/ SE forged pistons, 2007 ported heads w/ stock valves and springs, 2007 T/B bored to 50mm, modified V&H Pro Pipe, Woods TW-8 cams advanced 4 degrees, .030 nitrous jet
Non Nitrous 87.4 HP / 98.0 TQ
W/Nitrous 128.88 HP / 147.50 TQ
I mapped it after it had enough miles. I took it to a local Harley dealer to have it dynoed. I always have an independent dealer or tuner to dyno the bike so that I have no influence on the dyno results.
The build is typical (non-radical): Big bore w/ SE forged pistons, 2007 ported heads w/ stock valves and springs, 2007 T/B bored to 50mm, modified V&H Pro Pipe, Woods TW-8 cams advanced 4 degrees, .030 nitrous jet
Non Nitrous 87.4 HP / 98.0 TQ
W/Nitrous 128.88 HP / 147.50 TQ
Thread
Thread Starter
Forum
Replies
Last Post
No Device: Dyno Correction factors and smoothing
Wide Open Cycles
The Dyno Room
8
06-27-2016 12:20 AM
