HD Brawler Solo Saddle '09 RKC Pics & 1st Impressions
#21
Elvis Nixon,
Just got my Brawler seat today. From looking at your pics, how did you get your seat to fit so nice n close to your fuel tank instrument console? I have about an inch gap between the top part of the seat & my console? Can you possibly include pics with your explanation please? Thanks.
Just got my Brawler seat today. From looking at your pics, how did you get your seat to fit so nice n close to your fuel tank instrument console? I have about an inch gap between the top part of the seat & my console? Can you possibly include pics with your explanation please? Thanks.
As far as moving the seat closer to the tank console, you can do it to some degree. The bracket that attached the seat onto the mounting plate has two allen head screws. If you loosen those two a bit you can move the bracket and, accordingly, move the seat closer to the tank console. That's what i had to do to eliminate the gap.
Hope this helps.
#22
Another question,
I'm also going to be doing alot of swapping out between solo & stock seat...Do you have to take the bracket with the nut receiver off the fender each time you swap back to the stock seat? If you leave this on, wouldn't the receiver on the bracket poke into the bottom of the stock seat?
I'm also going to be doing alot of swapping out between solo & stock seat...Do you have to take the bracket with the nut receiver off the fender each time you swap back to the stock seat? If you leave this on, wouldn't the receiver on the bracket poke into the bottom of the stock seat?
I also swap out my Brawler with the stock seat when my daughter wants to go for a ride and I don't have to remove the Brawler bracket at all. It may depend on the seat you are swapping to, but there is enough room inside the stock two up seat to allow the Brawler bracket to fit without it poking through.
Hope this helps.
#25
FYI regarding pillion pad for use with brawler seat. if you have the 2or 4pt docking kit installed already you can use the rack for the solo tour pak to mount a pillion pad on that you can take on and off. Just wish the MOCO would design a backrest that already had a passenger seat attached to it that I could take it on and off the same way. Or a backrest that could be used with the solo seat with a luggage rack for my TBAG.. Anyone else looking for something like this???
#27
Thread
Thread Starter
Forum
Replies
Last Post